Go back to the Trac‑Rite commercial garage doors

Trac‑Rite 955

Trac-Rite Door Logo

The Trac‑Rite Model 955 Roll Up Door is designed for service in wide range of Light-Duty Commercial applications - including farm buildings,warehouses, car wash facilities, auto body shops… This Trac‑Rite roll up overhead door is your ideal choice for buildings with high eave structures or large door openings and low door heights.

Trac-Rite 955

Tough & Stylish With Maximum Wind Resistance

The Trac-Rite 955WL's continuous curtain of solid steel is available in a variety of stylish colors and in custom sizes from (8'-12'W) x (3'-12'8"H) in 1" increments. Maximum heights vary depending on width.

The Trac-Rite WindLock System

When wind blows against the 955WL steel curtain, the door's WindLocks engage with the door guide to produce a strong interlocking grip that maintains the curtain securely in it's guide to provide Maximum Wind Resistance.

Trac-Rite 955WL doors feature a 26-gauge rigid-rib steel curtain that is strong & tough, and requires very little maintenance. 955WL door drums and helical torsion EP3 springs provide strong curtain support and balance, while the door's permanently-sealed ball bearings ensure silky smooth operation every time they operate.

Trac‑Rite 955 door applications

Light‑duty commercial:

  • Auto Body Shops
  • Boat Houses
  • Car Washes
  • Cold Storage
  • Dock Doors
  • Machine Shops
  • Post Frame Buildings
  • Sheds
  • Warehousing Applications
  • High Eave Structures with Relatively Low Door Heights
Trac-Rite 955

Trac‑Rite 955 door specifications

Design type

Live axle: door axle rotates in bracket bearing during operation.

Drums

Stamped, continuously welded at the hub. 9‑5⁄8" diameter spiral x 1‑1⁄4" wide. 16‑gauge, zinc‑coated steel. Three drums with doors up to 8' wide, four drums with doors over 8' wide.

EP3 Springs

Helical torsion, oil tempered, and coated to halt corrosion and increase life. One spring for doors less than 5' high or for doors 7'11" wide and smaller. Two springs for doors 8' or more wide.

Axle

1‑5⁄16" outside diameter, schedule 80, steel tubing.

Tensioning System

Springs come with a zinc-coated cast steel tension wheel and winding bar for ease of adjusting spring tension.

Curtain

Roll‑formed sections, factory-seamed from 26-gauge, Grade 80 galvanized steel. Siliconized polyester finish in 13 standard colors. Full-length 2" felt tape located at each drum.

Bottom Assembly

Zinc-coated steel bottom angle mounted to corrosion-resistant aluminum extrusion with stainless steel bolts. TPE blade astragal also included.

Brackets

12‑gauge, cold‑formed, zinc‑coated steel. Grease‑packed ball bearings are factory installed in the bracket.

Guides

16‑gauge, zinc‑coated, 2‑¾" deep. Featuring polypropylene guide runners to assure smooth operation and prevent steel‑on‑steel contact.

Interior Lock

12‑gauge, zinc‑coated steel slide bolt engages a lock strike attached to the side guide. Two locks per door fasten to the bottom assembly and are suitable for padlocking.

Mounting Fasteners

Steel or wood fasteners included. For masonry openings, mounting clips and anchoring system are sold separately:

Steel:
Bracket: ¼" x 1" self‑drilling screws
Jamb: ¼" x 1" self‑drilling screws

Wood:
Bracket: 3⁄8" x 2‑½" lag bolt
Jamb: ¼" x 1‑½" self‑drilling screws

Masonry: For masonry openings, mounting clips are sold separately. Masonry anchors must be furnished by the Buyer.

Door Stop

12‑gauge, zinc‑coated L‑shaped stops mount to guides for increased strength.

Exterior Handle

Powder coated, zinc‑plated outside handle.

Pull Rope Handle

Molded plastic rope handle with long-lasting rope.

Design type Live axle: door axle rotates in bracket bearing during operation.
Drums Stamped, continuously welded at the hub. 9‑5⁄8" diameter spiral x 1‑1⁄4" wide. 16‑gauge, zinc‑coated steel. Three drums with doors up to 8' wide, four drums with doors over 8' wide.
EP3 Springs Helical torsion, oil tempered, and coated to halt corrosion and increase life. One spring for doors less than 5' high or for doors 7'11" wide and smaller. Two springs for doors 8' or more wide.
Tensioning System Springs come with a zinc-coated cast steel tension wheel and winding bar for ease of adjusting spring tension.
Axle 1‑5⁄16" outside diameter, schedule 80, steel tubing.
Curtain Roll‑formed sections, factory-seamed from 26-gauge, Grade 80 galvanized steel. Siliconized polyester finish in 13 standard colors. Full-length 2" felt tape located at each drum.
Bottom Assembly Zinc-coated steel bottom angle mounted to corrosion-resistant aluminum extrusion with stainless steel bolts. TPE blade astragal also included.
Brackets 12‑gauge, cold‑formed, zinc‑coated steel. Grease‑packed ball bearings are factory installed in the bracket.
Guides 16‑gauge, zinc‑coated, 2‑¾" deep. Featuring polypropylene guide runners to assure smooth operation and prevent steel‑on‑steel contact.
Interior Lock 12‑gauge, zinc‑coated steel slide bolt engages a lock strike attached to the side guide. Two locks per door fasten to the bottom assembly and are suitable for padlocking.
Mounting Fasteners

Steel or wood fasteners included. For masonry openings, mounting clips and anchoring system are sold separately:

Steel:
Bracket: ¼" x 1" self‑drilling screws
Jamb: ¼" x 1" self‑drilling screws

Wood:
Bracket: 3⁄8" x 2‑½" lag bolt
Jamb: ¼" x 1‑½" self‑drilling screws

Masonry: For masonry openings, mounting clips are sold separately. Masonry anchors must be furnished by the Buyer.

Door Stop 12‑gauge, zinc‑coated L‑shaped stops mount to guides for increased strength.
Exterior Handle Powder coated, zinc‑plated outside handle.
Pull Rope Handle Molded plastic rope handle with long-lasting rope.

Note: Product specifications are subject to change without notice.

Trac‑Rite 955 door wind load ratings

All Trac-Rite door models, both standard and WindLock, are put through rigorous wind testing - witnessed and certified by an independent test lab. Trac-Rite doors are approved for installation in buildings affected by Florida Building Commission regulations concerning wind testing and manufacturing certifications.

Note: Model 955WL roll up doors with windlocks provide maximum wind load rating.

955 Door width

  • 5'0"
  • 6'0"
  • 7'0"
  • 8'0"
  • 9'0"
  • 10'0"
  • 11'0"
  • 12'0"

955 Door PSF/MPH rating

  • 56.0PSF/150MPH
  • 42.0PSF/150MPH
  • 30.0PSF/150MPH
  • 24.0PSF/130MPH
  • 20.0PSF/120MPH
  • 17.0PSF/120MPH
  • 14.0PSF/100MPH
  • 12.0PSF/90MPH

Trac‑Rite 955 roll up door color options

Trac-Rite color - Garnet

Garnet

Trac-Rite color - Sunset Orange

Sunset Orange

Trac-Rite color - Polar Blue

Polar Blue

Trac-Rite color - Royal Blue

Royal Blue

Trac-Rite color - Cedar Red

Cedar Red

Trac-Rite color - Evergreen

Evergreen

Trac-Rite color - Continental Brown

Continental Brown

Trac-Rite color - Desert Tan

Desert Tan

Trac-Rite color - Iced White

Iced White

Trac-Rite color - Patriot Red

Patriot Red

Trac-Rite color - Matte Black

Matte Black

Trac-Rite color - Shale

Shale

Trac-Rite color - Bright White

Bright White

Trac-Rite color - Vivid Yellow

Vivid Yellow

Trac-Rite color - Ash Gray

Ash Gray

Trac-Rite color - Light Stone

Light Stone

Trac-Rite color - Lime Green

Lime Green

Copyright Garaga Inc. | Privacy Policy and Conditions of Use | Sitemap